F. Dick Magneto Steel HyperDrill Knife Sharpener

Integrated magnets guide the knife into the sharpening unit at a set angle on the Magneto Steel HyperDrill, and the abrasive dust collects on the magnets rather than the blade. It is a sharpener for meat processing where speed and consistent results matter.

Reworked fine cut HyperDrill II rods remove material finely and evenly and smooth the edge in the same pass. Steel protective plates keep the knife aligned inside the unit and stop plastic particles from getting into the meat. The fully enclosed mechanism resists outside elements, and recessed grips on the front give a secure hold, even in gloves.

Mounting it at the station keeps the sharpener within reach for every cutter on the line.

For a lighter hand unit, the Master Steel HyperDrill II uses similar rods. A spring-free option is the Silver Steel HyperDrill, and the Rapid Steel HyperDrill II has a locked mechanism box.

SKU: D9 0084 400-77

Availability: In stock

$105.00
  • Details

    Specifications

    • Rods: HyperDrill II, reworked fine cut stainless steel
    • Guidance: Integrated magnets set the angle and collect abrasive dust
    • Springs: Tension springs with no measurable wear
    • Mounting: Hand-held, or two mounting holes in the base; two eyelets in the handle for a chain or lock
    • Made in: Germany
    • Item number: 90084400-77

    F. Dick Knife Sharpeners Compared

    For a traditional steel instead, our best-selling steel overall is the EuroCut 12-inch Round Regular Cut Steel.

    SharpenerRodsMechanismBest for
    Rapid Steel Action Set with BaseAction, ultra-hard special coatingTension springsHigh abrasion on all steel types
    Rapid Steel HyperDrill II Knife SharpenerHyperDrill II, reworked fine cutTension springsMeat processing
    Master Steel Polish Knife SharpenerPolishedTension springsStraightening and smoothing
    Master Steel HyperDrill II Knife SharpenerHyperDrill II, reworked fine cutTension springsFine, even material removal
    Master Steel Ultra-Fine HyperDrill Knife SharpenerUltra-fine HyperDrillTension springsFine, even material removal
    Magneto Steel HyperDrill Knife SharpenerHyperDrill II, reworked fine cutSprings and guiding magnetsSet angle, dust kept off the knife
    Silver Steel HyperDrill Knife Sharpener2 x 2 HyperDrillNo springsHygiene-critical plants

    How to Use

    Hold the sharpener in your less-dominant hand, or mount it in a holder. Lean the blade slightly against one side of the slot and draw it through the rods from heel to tip with light pressure. Use the spring action of the rods without pushing the knife to the bottom of their travel, and repeat a few times.


    Good to Know

    These are honing tools. They straighten, align and smooth an edge that already has a bevel; they will not put a new edge on a dull knife. For that, use a sharpening machine or whetstones.


    Care

    Rinse the sharpener under warm running water after use to clear metal particles, then let it dry. Replace the rods when they stop restoring the edge.

    Additional Info

    SKU D9 0084 400-77
    Brand Friedrich Dick
    Country of Manufacture Germany
    Manufacturer's Part Number 90084400-77
    Manufacturer's Suggested Retail Price $168.00

    Write Your Own Review

    You're reviewing: F. Dick Magneto Steel HyperDrill Knife Sharpener