You have no items in your shopping cart.
Sharpening Stones
-
Minonokuni 4000 Grit Waterstone
Minonokuni’s 4000 grit waterstone is a traditional Japanese finishing stone, custom specified by Minonokuni’s craftsmen for Knife Merchant and tested extensively in regular use in our own kitchen. It refines the edge left by a 1000 grit stone and polishes it to a mirror finish.In our testing, the stone gives clear feedback, builds a slurry easily and resists dishing, so it stays flat over repeated use. The polish it leaves is noticeably finer than other stones of comparable grit, which shows on the bevel of a yanagi or usuba and on the cut surface of the food.
A Two-Stone RoutineWe pair this stone with the Minonokuni 1000 grit waterstone. Together, the two are enough for a complete, simple sharpening routine, from re-establishing a dull edge to creating a refined, mirror finish. For damaged edges, add the Minonokuni 220 grit waterstone at the start.Soak the stone until the bubbles stop rising, and keep the surface wet as you work. A finishing stone suits single-bevel slicers such as the Matsu 240mm yanagiba, where a polished edge leaves sashimi with a clean, glossy face. Learn More$69.95 -
Minonokuni 220 Grit Waterstone
A 220 grit stone is for repair rather than routine sharpening. It is the stone to reach for when a knife has a chipped edge, a broken tip, a dip worn into the edge (a reverse curve) or a bevel that needs to be reset, jobs that would take far too long on a medium stone.Because it is aggressive, it removes steel quickly. Work with light, even pressure and check the edge by eye at short intervals, then move to a finer stone as soon as the damage is gone. Every scratch the 220 leaves has to be removed by the next stone, so stopping early saves time overall.
Building a SetA coarse stone is the first of three steps in a Japanese sharpening setup. After the 220, the Minonokuni 1000 grit waterstone restores a working edge, and the Minonokuni 4000 grit waterstone refines and polishes it. A cook whose knives are in good condition can start with the 1000 and add the 220 only when an edge needs repair.This stone needs a fair amount of water, so give it a full soak before use and keep the surface wet as you work. For single-bevel knives such as the Take 240mm yanagiba, use the 220 on the beveled face only, never on the flat back. Learn More -
Minonokuni 1000 Grit Waterstone
The 1000 grit waterstone is the everyday stone for keeping an edge sharp. It is coarse enough to bring back a dull blade and fine enough to leave an edge that is functionally sharp, which makes it the stone to buy first and the one that sees the most use.Japanese sharpening stones fall into three levels of abrasion. There is a coarse stone for repairing chips or reshaping a badly worn edge, a medium stone for maintenance and re-establishing a working edge, and a finishing stone for polish. This stone sits at the middle stage, so it covers the routine sharpening of most kitchen knives.
Using ItSoak the stone until the stream of bubbles stops, then keep the surface wet throughout sharpening. Hold a steady angle and work the full length of the edge until a small burr forms along the opposite side, then repeat on the second side. Let the stone air dry fully before storing it.For a higher polish, pair it with the Minonokuni 4000 grit waterstone; for chips and broken tips, add the Minonokuni 220 grit waterstone. It suits both Japanese and Western knives, including the single-bevel Ume 150mm deba, the line we recommend for learning to sharpen. Learn More$49.95 -
Minonokuni Sharpening Stone Set
This is the Minonokuni 3 piece sharpening stone bundle. These are fantastic stones for any sharpener due to their quality and sharpening properties.
Items Included: 220 Grit - Great for very dull or damaged knives. Use this stone to form a burr and set a bevel.
1000 Grit - Maintenance stone for touching up dull knives. Frequently used to refine or continuing to establish the bevel and form a burr.
4000 Grit - The finest grit stone in this set. Intended to polish the marks left from the previous stones so the knife's edge is as smooth as possible. Ideal for cutting fish and meat.
Made in: Japan Learn More
