You have no items in your shopping cart.
Sharpening Accessories
-
F. Dick Holder for Master Steel Sharpener
Fixing a Master Steel to the workstation leaves both hands free to guide the knife, and this F. Dick holder does that. It fits the Master Steel Polish and the Master Steel HyperDrill.The holder screws onto the workplace without special tools. It sets the sharpener in one of three positions, facing straight out or angled to the left or right, so a cutter can choose the angle that suits the station and the hand they cut with. A hole at the handle end lets the sharpener be chained or locked to the table to keep it from walking off.Mounted at a comfortable height, it lets each cutter pass the knife through with the same motion every time.It fits the Master Steel Polish, the Master Steel HyperDrill II and the Master Steel ultra-fine HyperDrill. For a sharpener that mounts directly with its own holes, see the Magneto Steel HyperDrill. For other Master Steel parts, call us at 1-800-714-8226. Learn More$21.45 -
F. Dick Polishing Wheel for SM-100
After grinding, a fine burr remains along the edge, and this F. Dick felt polishing wheel removes it on the SM-100 sharpening machine. Used with buffing compound, it hones and polishes the edge to a smooth finish.A burr left on the edge rolls over in use and dulls the knife quickly, so polishing is what makes the freshly ground edge last. The wheel holds compound evenly across its face for consistent results through a long sharpening session. Replace it when the face is worn or glazed and no longer takes compound well.Fit the wheel with the machine unplugged, and run it briefly before loading compound so it settles. Light, even contact with the wheel gives the best finish on the edge.This wheel fits the F. Dick SM-100. Load it with the white polishing compound, and keep a supply of SM-100 grinding belts for the grinding stage. Learn More$97.50 -
F. Dick White Polishing Compound for SM-100
This white buffing compound is the replacement for the F. Dick SM-100 polishing wheel. It is formulated for final finishing and burr removal, the step that turns a freshly ground edge into a smooth, refined one.Applied to the spinning felt wheel, the compound works as a very fine abrasive that clears the burr and polishes the bevel. A wheel without enough compound glazes and stops polishing, so reload it lightly at intervals during a session. A smooth, polished edge cuts cleanly and stays sharp longer.Hold the compound bar lightly against the spinning wheel for a moment to load it, then polish the edge with light contact, keeping the edge trailing the direction of rotation. Store the bar in a closed container so it stays clean and does not dry out.Use it with the SM-100 polishing wheel on the F. Dick SM-100. Grinding comes first, on the 120 grit SM-100 belts. Learn More -
Idahone | Plastic Guard Replacement (for CS-24)
Replace your worn or damaged guard with this genuine Idahone plastic guard replacement for the CS-24 sharpening system. The integrated hand guard provides added protection during use, while the included screw makes installation simple and straightforward. Includes one plastic guard and one screw. Learn More
