You have no items in your shopping cart.
F. Dick Honing Steels
For the last two hundred years, F. Dick steels have been widely recognized as the best made at world fairs and other competitions. Professional butchers likely have the best understanding of steels, or honing rods. Their work demands they start with a very sharp edge and they hone their knives every ten to fifteen minutes while working. Nearly all butchers use a polished or fine cut steel because they remove a minimum amount of metal from the edge of the knife. They will only realign the existing edge, which is what a steel is designed to do.
Our recommendation is to work with a very fine stone to rebuild your edge and a fine-cut F. Dick steel to keep it straight. When you are working as a carver / butcher, honing your knife four to six times an hour, for a full shift, you will probably want to use a Friedrich Dick polished steel in order to avoid wearing the edge down. Most cooks hone the knife before starting work or after taking it to the sharpening stone. For them, the F. Dick regular cut steel works well. If you keep the knife edge aligned, you won’t have to grind a new edge as often and the knife lasts longer.
-
F. Dick 10-inch Square Regular and Fine Cut Combination Steel
Meat processors and serious cooks who hone constantly can work two cuts from one rod with this 10-inch square F. Dick steel. Two faces carry a regular cut and two carry a fine cut.The regular cut faces straighten a rolled edge and restore bite on a knife that has been working on bone and joints. The fine cut faces then smooth the edge for clean portioning. Four working faces also spread the wear across more of the rod. Accurate portions depend on a knife that stays sharp through the shift, which is what this rod is for.One rod also saves space at the station.For a smoother finish, the F. Dick 10-inch square polished and fine cut steel swaps the regular cut for polished faces. A round rod with a single regular cut is the 10-inch round steel with non-slip handle. Our honing steel guide explains when to use each cut. Learn More$66.30 -
F. Dick 10-inch Square Polished and Fine Cut Combination Steel
Four faces give this 10-inch F. Dick combination steel two finishes in one rod, with two polished sides and two fine cut sides. Butchers and meat processors who need to work efficiently can choose the edge for the job without reaching for a second steel.A polished edge is very smooth and suits cutting proteins into even portions. The fine cut sides leave a slightly rougher edge with a little bite, which helps when slicing tomatoes and other fruit and vegetables. The flat faces of the square rod also make it easy to see and hold the angle.It also suits a crowded knife roll.For more correction, the F. Dick 10-inch square regular and fine cut steel pairs a regular cut with a fine cut. A Dickoron version with sapphire and polished faces is the Dickoron Combi 12-inch square steel. A single polished rod is the Poliron 10-inch oval steel. Learn More$77.35
