F. Dick Honing Steels

For the last two hundred years, F. Dick steels have been widely recognized as the best made at world fairs and other competitions. Professional butchers likely have the best understanding of steels, or honing rods. Their work demands they start with a very sharp edge and they hone their knives every ten to fifteen minutes while working. Nearly all butchers use a polished or fine cut steel because they remove a minimum amount of metal from the edge of the knife. They will only realign the existing edge, which is what a steel is designed to do.

Our recommendation is to work with a very fine stone to rebuild your edge and a fine-cut F. Dick steel to keep it straight. When you are working as a carver / butcher, honing your knife four to six times an hour, for a full shift, you will probably want to use a Friedrich Dick polished steel in order to avoid wearing the edge down. Most cooks hone the knife before starting work or after taking it to the sharpening stone. For them, the F. Dick regular cut steel works well. If you keep the knife edge aligned, you won’t have to grind a new edge as often and the knife lasts longer.

3 Item(s)

per page

  • F. Dick 14-inch Round Regular Cut Steel with Non-Slip Handle

    Long curved blades such as scimitars and breaking knives need extra length to hone properly, and this 14-inch round F. Dick steel provides it with a secure, non-slip handle. Butchers who hone constantly to keep portions and yields consistent on pork and beef will find it a practical tool.The regular cut straightens edges dulled by bone and joints and restores bite for trimming fat. A sealed handle keeps the steel suitable for the cleanest cutting environments. At this length, the rod lets a 12-inch blade sweep its full edge without running off the tip.A longer rod also keeps the hand farther from the edge as the knife sweeps toward the tip.For knives under 10 inches, the 12-inch round steel with non-slip handle is easier to carry. A black-handled butcher version is the F. Dick 14-inch round butcher steel, and the Dickoron Classic 14-inch round steel adds a sapphire cut. Learn More
  • F. Dick 14-inch Round Regular Cut Butcher Steel

    Long knives need a long rod, and this 14-inch F. Dick butcher steel gives scimitars, breaking knives and doner slicers enough length to sweep the full edge. It is built for butchers and processors who work with blades over 10 inches.A metal finger guard adds weight to the handle end, which balances the long rod and protects the hand. The regular cut straightens edges dulled by bone and joints and leaves enough bite for clean trimming. The extra length makes it harder to fit in a knife roll, so it is best kept on a hook or in a scabbard at the cutting station.For knives under 10 inches, the 12-inch round butcher steel is easier to carry. The same length with a sapphire cut is the Dickoron Classic 14-inch round steel, and a non-slip handle version is the F. Dick 14-inch round steel with non-slip handle. Learn More
  • F. Dick Dickoron Classic 14-inch Round Sapphire Cut Steel

    Butchers, meat processors and cooks who carve shawarma and gyro with long slicers need a long rod, and this 14-inch Dickoron Classic adds the sapphire cut to that length. It is also well suited to curved scimitars and breaking knives.The extra length lets a 12-inch blade sweep its whole edge in one stroke, so the angle stays consistent from heel to tip. The fine, straight sapphire striations give velvety-soft honing and leave a uniform, fine edge. F. Dick cuts the lines with modern production methods so they run even and at the correct depth.Hang it at the station between cuts.For knives up to 10 inches, the Dickoron Classic 12-inch round steel is easier to carry. A regular cut at this length is the F. Dick 14-inch round butcher steel. A scabbard such as the F. Dick Knife Scabbard with Belt carries the steel with the knives. Learn More

3 Item(s)

per page